wiki:TestingAPSDirect

Version 1 (modified by nanang, 11 years ago) (diff)

Initial version of testing APS-direct.

Testing APS Direct

Objectives

  1. Find APS-direct bugs.
  2. Identify problematic devices or firmwares.

Requirements

  1. S60 3rd edition device(s), MR, FP1, or FP2.
  2. Appropriate version of APS server (apsserver2.sisx), installed on the device.
  3. Test application, symbian_ua, can be downloaded here:
  4. Test partner, it can be any endpoints that support all/some of test codecs: APS codecs (i.e: AMR, G.729(B), iLBC, PCMA/U) and non-APS codecs (i.e: GSM, Speex). However for easiness (logs file, instructions) this test is using PJSUA app for desktop built with IPP codecs (support all test codecs).
  5. LAN environment, to avoid the possibility of NAT problems.

Testing Steps

  1. Register your IMEI to get the test application installer signed with our developer certificate here.
  2. Install and run the test application.
  3. Run test partner application with test codecs enabled, note that please only enable the test codecs since enabling all codecs may cause the SIP message size larger than MTU. Please specify --log-file and use log level 5 for reporting. Enabling/disabling codecs in PJSUA can be done via 'Cp' command, setting codec's priority to 0 will disable the codec.
  4. Enable one codec from the test application:
    • Choose menu 'd' Enable/disable codecs, codecs selection menu will be shown.
    • Choose one codec to test, e.g: start from the top, AMR.
  5. Make normal call from test partner to test application. Things to check here:
    • Two ways audio.
    • Quality.
  6. Test audio routing in the test application, i.e: by choosing menu 't' Switch audio route, it's a toggle. Thing to check here:
    • if audio route is switched from earpiece to loudspeaker.
    • vice-versa, after pressing 't' again.
  7. Repeat the steps from point 4 to test other codecs (without restarting test application).

Uploading Reports

  1. When everythings are just fine, just report OK.
  2. When something goes wrong, please specify in details the problem and steps to reproduce, whenever you think that test partner's log file may help, please send it along.

Thanks!